Jump to content

Planing the gunwales


calligraf
 Share

Recommended Posts

Hi, I'm building a solo Crawfish and am now ready to attach the gunwales. The instruction book reads, "...you will need to flatten the top edge." Does this simply mean that you want a straight, consistent surface along the length of the gunwales where the spacing blocks will be placed? Or do the gunwales need to be planed down so that the top surfaces (inner and outer gunwales) are parallel to the floor? I'm a bit confused as the top edges are already flat since I ran them through my table saw.

Link to comment
Share on other sites


You should repost this to the Kudzu section.  Jeff will likely see it if you do, he may not come here much. It would also help to copy the whole paragraph around your quoted section above.  More context would help a lot of people answering this.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


Supporting Members

Supporting Members can create Clubs, photo Galleries, don't see ads and make messing-about.com possible! Become a Supporting Member - only $12 for the next year. Pay by PayPal or credit card.




×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.