Jump to content

calligraf

Members
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About calligraf

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thank you, I will do that. Hadn't even noticed that I put it in the wrong section.
  2. Hi, I'm building a solo Crawfish and am now ready to attach the gunwales. The instruction book reads, "...you will need to flatten the top edge." Does this simply mean that you want a straight, consistent surface along the length of the gunwales where the spacing blocks will be placed? Or do the gunwales need to be planed down so that the top surfaces (inner and outer gunwales) are parallel to the floor? I'm a bit confused as the top edges are already flat since I ran them through my table saw.
  3. Ok. I'm getting a better understanding of it now. Thank you!
  4. Hi! I'm new to this forum and hoping someone can help me. I'm building a Kudzu canoe (Crawfish 14'), and unfortunately there aren't any photos of this boat in the manual. I'm doing fairly well so far, but I'm not sure how to attach the Bow and Stern pieces to the keel, and how the stringers should be attached to those pieces, as well. Do I need to drill holes through the Bow and Stern pieces so that I can tie the stringers to them? Any help would be greatly appreciated!
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.