Search the Community
Showing results for tags 'nesting'.
-
Hi everyone, this is my first post--I've been lurking here getting lots of good info as I build and finally have a few questions myself! By now the boat is 3D and wired together. The hull, bulkheads, and transom all seem to fit well, and the boat has no twist in it that I can discern. Measurements from the peak of the bow to the corners of the transom are 109" +/- an 1/8", and sighting down the centerline, the tips of the nesting bulkheads "disappear" below the transom at the same time. I've made a number of spanish windlasses to pull the sides together between the forward and mid bulkhead, to pull out the 1/2" gap between the bottom and the bottom of the nesting bulkheads, to pull the forward bulkhead forward onto its lines, and lastly to try to flatten the bottom seam between bulkheads slightly to close a gap in the bottom panels. The question is how much of a gap along the keel seam is acceptable? It goes from no gap at the transom and widens to about 1mm around the nesting bulkheads, and up to a maximum of about 3mm halfway between the forward and mid bulkheads. I think the epoxy fillets will cover it just fine, but I just want to make sure it's not a symptom of a larger problem. Also, the plans don't really give dimensions to make a breasthook or quarter knees--do I just make these to fit the shape of the hull as it stands now? The instructions say the breasthook (included with the kit I suppose) is important to ensure the bow takes the correct shape--so what gives? The sheer lines look nice. Lastly, I centered the kerf gap of the nesting bulkhead on the "center frame" lines running down the sides--is that correct? Thanks! Additional photos Looking aft: chine bow and gap forward bulkhead
-
As my first post on this forum I may as well start a build thread. I should start out by saying I have little to no experience with boats, but I love building things and my wife says we don’t need any more bookshelves or lawn furniture. I have read many of the build threads on this site and have appreciated being able to get a more in-depth understanding of the process. I also watched Alan's set of videos. So one day I called and talked to Alan, and ordered the kit. The next thing you know I have a large stack of wood parts, several bottles of epoxy, and rolls of fiberglass tape. Onward, Mike