[/img]
Shown above image is the underside of the Mighty Mite 2 hp motor series 800.
I have great difficulty starting this motor. No manual is currently available .
It requires direct squirt of raw gas into the cylinder. When it finally kicks off it runs for a few seconds and then dies.
If you do get it going it takes full choke to sustain it to run, then switched befores it dies, to the run position.
The controls on the face have a (L to R ) START, CHOKE, RUN, positions.
The thottle and spark advance indicate the setting for shift only.
The key I think to get this motor to start and run properly is to have the initial settings to be set correctly on the carbureator as shown in the image. The prominent screw on on the bottom of the carbureator( what appears to be the float chamber) is for ? and the screw appearing to the left and horizontaly in the image is for what? Any body have any clue as to the initial settings ?
BTW the gas oil ratio for this motor is 25 to 1
JD
--------------------------------------------------------------------------------