Jump to content

glm

Members
  • Posts

    7
  • Joined

  • Last visited

Everything posted by glm

  1. Not sure if anyone has attempted to install a cabin on a Ocracoke. Greg
  2. Hi Matt I have glued the last layer on my keel today, just about done. As far as the stem goes, I have as many as 3 joints in the 3 layers. As long as you stagger the joints as much as possible you should be good. I glued the doublers on the frames as they where being fabricated. I cut the transom layers from a template, then laminated the layers on the transom jig as per blueprint. I will try to attach a couple of pictures of my keel. Greg
  3. Fishman 38 I have used Dupont Imron on the last 2 boats that I have built, with no issues. The last boat has 700 hrs on it over the past 4 years and other than the usual scuffs, I have had no problems with blisters or peeling. Dupont also does not recommend use below the waterline, however if the boat will spend most of its time on a trailer I feel you would have no issues. Imron is very easy to apply with a spray gun, however I think Dupont has come out with a brush/roller version geared to the marine industry. I to am building the OK 20 and will be using Imron without concern.
  4. I agree with Alex, I to have built several boats over the years, and I have found pre coating the panels much easier than after assembly. If your coatings are done properly, I doubt that your fillets and glass would be an issue, if they are sanded primer to coating. Check with your epoxy supplier, I would suggest they will agree. I use mas epoxy with no issues. Greg
  5. Good afternoon I am new to this form and have been following the progress of both boats for some time. I have just finished the frames for the Ocracoke 20' however I live up in Ontario and the fall weather has stopped any epoxy work outside. I to have wondered about floatations, and have found closed cell foam in the form of balls. The balls come in various sizes from about 1/2 to several inches in size. This would allow for air ventilation as well as drainage if needed. No need for gluing foam in place, just fill the cavity. I found a company in MI that manufacture them, at a reasonable price compared to pour in place foam. Keep the builds going, the boats look great. Greg
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.