Charlie Jones Posted March 8, 2007 Posted March 8, 2007 Both Hamilton Marine and Jamestown have bronze ring nails with much smaller heads than that. Like 1/8th. The plans call for the seats being nailed. You could more than likely do fine without it, but I wouldn't. Failing getting the nails, you could use some 3/4 #6 stainless screws and screw them down, countersinking them then epoxy fill the heads with an epoxy/filler mix. Quote
Joe Nelson CS#35 Posted March 9, 2007 Posted March 9, 2007 I didnt leave any fasteners in my CS20. except for the rub rails and the thwart. As long as you have good sized nailers as framing to get a decent amount of glue surface, you should be just fine with putting it together with drywall screws and pulling them after dry. Quote
chipveres Posted March 9, 2007 Posted March 9, 2007 If you are planning to varnish or oil the thwarts, you could counterbore for the screws and put dowels or little rounded plugs over them. The little round plugs are available from Rockler or Constantine's. I wouldn't take that much trouble on my boat, but some folks do. Quote
James Bandle Posted March 9, 2007 Author Posted March 9, 2007 Thanks guy's ... some great ideas! Jim Bandle Quote
mustangermatt Posted March 9, 2007 Posted March 9, 2007 No screws on my 17, just tape and epoxy. I have pounded the boat for two years and it has held together. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.