Jump to content

Ocracoke 256 #3


Guest Chris Beebe
 Share

Recommended Posts

  • 5 months later...

Finally got the rub rail installed, 1" solid back SS as per plans. A lot of work fitting , bending & polishing we have been running her with out it and it had been worrying me we also installed the rest of the electronics ( radar, search light, tunes and a few other stuff). 

 

0004.JPG

0005.jpg

  • Like 1
Link to comment
Share on other sites

The reason we used solid back rub rail is because it bends better the hollow back will flair and spread on tight bends, also the hollow back will cut the paint and finish when it gets hit. I did not want to spend that much  but I ended up getting a really good deal on the material through a friend. It took 110' of rub rail 16' sections and about 20 hours of labor to get it fitted. Some of the bends are pretty tight and hollow back will not have made it look as good.

Using hollow back is definitely cheaper ( probably 1/5 of the cost) but also when you have an end piece you will have to use a prefabricated  end and that looks OK just not what I wanted, when we installed the rail we coated the back of it with 4000 UV and also all the screws where sealed.

00020.JPG

00022.JPG

00027.JPG

Link to comment
Share on other sites

I used solid bronze on my Lapwing (stem to keel) for the same reasons, though I didn't have any tight curves.  Another negative is the weight, which is important to me even though my boat is a casual daysailor.  It just seems like it is worth it where fending off is concerned.  As always: "Damned 'cause it's all connected".

 

Nice job on the fitting/shaping.  Looks sharp and like it will function well.

Link to comment
Share on other sites

One of the things I always first look at on a home built are the edges; chines, deck lines and rails. Getting these on, so they look straight, even if they're curved in all three planes, can be daunting and a sure sign of a novice builder if they aren't. When I visited Chick a couple of years ago, he noticed as I walked up his driveway, I was eyeballing the lines, the chine, the raised deck line, etc. Yeah, I got caught, but it's what experienced builders do, we can't help it. He'd done such a nice job, he had little to be concerned about anyway. Another thing I focus on is the intersections of pieces, like a break in the half oval at the bow eye, just to be continued further up the stem, a windscreen cross brace, etc. Are they balanced, proportional, symmetrical? Same deal, it's what draws the eye and focus, so areas you can divide the men from the boys.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.