Jump to content

Ocracoke 256 hull #2 Build


smccormick

Recommended Posts


  • 3 weeks later...
  • 2 weeks later...
  • 1 month later...

I've knocked them off then put them back on.  When I looked at the cost and time to bag everything vs. radiusing, I just couldn't justify it.  I have, on the other hand, glassed internal, non-structural, low wear edges with a strip of glass.  I don't have any problem with running the glass up the sides of a piece and then applying another piece on the edge/face.  I am just careful when I sand to avoid going through the sharp edge.  I wouldn't do this with hull bottom/chine areas, but bulkhead edges I wouldn't hesitate.

Link to comment
Share on other sites

  • 2 weeks later...
  • 2 months later...
  • 3 weeks later...

I've been hanging out for an update - looking really good!

I like the clean interior edges.

Is that teak on the comings?

re the 302, are you also using 'awlfair' for the deeper depressions?

can the awlfair go straight onto raw FRP or require epoxy primer underneath?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


Supporting Members

Supporting Members can create Clubs, photo Galleries, don't see ads and make messing-about.com possible! Become a Supporting Member - only $12 for the next year. Pay by PayPal or credit card.




×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.