Jump to content

Search the Community

Showing results for tags 'repair'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Boatbuilding
    • Main Forum
    • B & B Yachts Forum
    • Bluejacket Boats
    • Kudzu Craft Forum
    • Design Forum
  • Boating
    • Lake DuBay Sailing Association
    • Boating & Crusing Stories
    • Boat Maintenance
    • Classifieds
  • Woodworking
    • General Woodworking
    • Power and Hand Tools
    • Shop Built Tools and Jigs
  • HOSTkabob Support Forums
    • Web Hosting Q & A
    • Website Q & A

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start











Supporting Member Since

Between and

Found 3 results

  1. See attached picture to see what I'm looking to repair. Basically, over the years the centerboard has damaged the plywood after hundreds of slams into it from the centerboard going in the down position. I'm thinking of getting some epoxy between the de-laminated plywood layers, clamp together lightly (using wax paper to separate clamp from epoxied surfaces), and then overlaying with a strip of fiberglass later. What do you think?
  2. My tiller broke today on my cs17 in the middle of the lake. Made a duck tape repair on the water and was able to let the wind blow us back to my side of the lake. Thankfully, the wind was blowing the right way. I bought this boat as the third owner, but I think it came with the plans so I should be able to re-make what I need for the repair. Wondering whether there are any updates to the design that might help me. Also wondiering about the wood choices. Wood that broke looks dark and slightly reddish. Mahogany? Are there any drop-in consumer replacements that I should consider? Does B and B sell the rudder/tiller assembly as a kit? Thanks in advance for your help. I'll attach some pictures.
  3. Hi everyone, I built my S9N in NC a couple of years ago. It has served me quite well. I recently had an incident; bringing my S9N back to FL from NC it came loose from the top of the car and crashed onto the freeway. The aft half sustained very minimal damaged. The forward half didn't fair as well. I have a couple of gunwale to chine cracks through and through. However the worst part for me is the gunwales. On the port side I have just about 16 inches handing on in good shape, the rest of the port side gunwale is splintered on the freeway. The Starbord side has a little more than half it's length left although it is going on by a couple of inches. Does anyone have any advise for repairing or replacing these forward half gunwales? I appreciate the help and will gladly send photos if need. Thanks, Ralph G
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.