Jump to content

Search the Community

Showing results for tags 'moccasin'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Boatbuilding
    • Main Forum
    • B & B Yachts Forum
    • Bluejacket Boats
    • Kudzu Craft Forum
    • Design Forum
  • Boating
    • Lake DuBay Sailing Association
    • Boating & Crusing Stories
    • Boat Maintenance
    • Classifieds
  • Woodworking
    • General Woodworking
    • Power and Hand Tools
    • Shop Built Tools and Jigs
  • HOSTkabob Support Forums
    • Web Hosting Q & A
    • Website Q & A

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start











Supporting Member Since

Between and

Supporting Member Until

Between and

Found 3 results

  1. Completed my Moccasin 14 kit last week and wanted to share the build album with the group --> https://photos.app.goo.gl/fL9gVryLLU176GUa6 First timer here... great experience and can't wait to take on another project someday... ...
  2. While visiting my father in Colorado, we finally started on his Moccasin 2 build with plans we've had for a couple of years. Quick synopsis of the build so far: Bought 4mm Okoume, with a tight grain 16'x6"x3/4" board of fir. We decided with the cost of the nicer lumber in the area, the entire boat would be mostly fir. Easy to loft, and cutout using a circular saw, and Japanese saw for a couple of places where the saw blade was to big. Cut two of the bow sections out together, and then made sure all four matched exactly before going any further. Had to flip the boat twice, because we should have started on the outside for initial seams. For flipping ran cross sections with small clamps securing and then a long board, with a screw into each cross section board. Cracked a forward hull panel, while wiring up bow stem. That right now is epoxied, and sandwiched between a layer of glass tape on each side. Questions?
  3. Hi All, I am seeking a little assistance with alignment of the butterfly on a Flyfisher 13' canoe. Assistance provided by Graham(designer) I have marked and cut the bottom according to the Cut out Sheet (metric) and have an A- B line of 0.411m with the angle BAB of 78deg. I have marked the side / bow according to the Cut out Sheet (metric) and have an A-B line of 0.401. There was a small typo on the metric plan I have double checked all measurements and even calculated the lengths and angles to verify. Is this correct that the AB straights on the bottom and sides should be of different lengths? No Assuming this is correct 1- if I align the AB edges at A the side will be out by around 6mm and the butterfly will cross the LCL extension line all the way from A to C 2- if I align the AB edges at B the side looks good but the butterfly will cross the LCL extension line 12cm from A on the A to C line. This will cause the sections to overlap when doing the tape and epoxy butt join. Is 2 what is intended? I am unable to (quote from plan page Hull assembly) "" Position the A-B straight of the side/bow against the A-B of the bottom so that the straight A-C line of the bow section falls on the extension of the bottom LCL" I believe that to achieve this either the bow 39deg or side/bow 143 deg angle would have to be reduced. With new measurement provided it all lines up perfectly Please help, any and all assistance greatly appreciated. Regards Brett South Australia Will post photos when done
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.