I am in the process of building a new Core Sound 17 mk 3 and have a few questions about the centerboard trunk. I am getting ready to seal the centerboard trunk and glass it into the boat. I have seen several threads on here that mention a rubber pad or bumper inside the trunk. It does not mention it on the page in the instructions that deals with building the trunk, but it does show it on the page where it shows rigging the centerboard. It seems like it would be much easier to put a bumper of some kind inside before I seal it up. What have others used for that bumper? How do you fasten it.....epoxy it?
Also, on the assembly page is shows filling the pivot pin hole with epoxy and then drilling it out. On the rigging page it shows not drilling all the way thru so that it only has to be sealed on one side. Already drilled it before I saw that so will need to refill part of the hole. Not really a problem, just wondered how others had done theirs.
Any insight would be appreciated. I am probably obsessing about this a little too much, but I would rather fix my mistakes before it is glassed in place.