Jump to content

Search the Community

Showing results for tags 'skid'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Boatbuilding
    • Main Forum
    • B & B Yachts Forum
    • Bluejacket Boats
    • Kudzu Craft Forum
    • Design Forum
  • Boating
    • Lake DuBay Sailing Association
    • Boating & Crusing Stories
    • Boat Maintenance
    • Classifieds
  • Woodworking
    • General Woodworking
    • Power and Hand Tools
    • Shop Built Tools and Jigs
  • HOSTkabob Support Forums
    • Web Hosting Q & A
    • Website Q & A

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


MSN


Website


ICQ


Yahoo


Jabber


Skype


Location


Interests


Supporting Member Since

Between and

Found 1 result

  1. Hi All--I picked up a CS17 almost a year ago. Yesterday I finally got it flipped over for some maintenance on the keel. There is some exposed wood and am not sure the best way to go about this. Looking for input from the fine folks here. First, I plan to take off the aluminum rail and the two steel (not stainless) trailer "roller guards" (the aluminum covers the front 2/3 of the keel--the back only has the two guards). Next, I plan to remove the paint the length of the keel (and an inch or so on either side of it) and start removing bad wood. If it's not too bad, I'm thinking I'll fill it up back to original form with thickened epoxy (with wood flour). If there are places where it's worse, I'll carve out that section and epoxy some oak in to replace it. Because I didn't build it, I'm not sure how it was constructed but it looks like the keel was glassed. After I fill it all back in, should I reglass it? One layer? And am I better to use something other than aluminum? I've read about brass and all that, but most of this wear comes from the trailer, not use in the water or on beaches. Second, as you can see in the pictures, the bow takes a little bit of a beating. I primarily boat in the saltwater around Camano and Whidbey Islands north of Seattle. The beaches are pretty rocky most of the time (and I do my best to find the "softest" landings I can). You can also see some of the roller scars from not quite getting it lined up before pulling in onto the trailer. (I'm getting better at it but I sail single-handed a good bit of the time--and sometimes the water conditions are pretty choppy at retrieval) I'm wondering what options I have to keep this part of the boat better protected. Extra layers of epoxy? Some strips of glass? Other? Thanks in advance. -Bryan
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.