Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 05/07/2019 in all areas

  1. Ben, The angle between the sheer and the top of the bow transom is approximately 115 deg. That would be the angle of the forward quarter knee (or very close to it). The bevel angle of the stiffener on the bow transom will not be this angle because the bow transom has a lot of rake compared to the stern transom. Measuring the angle at 90 degrees to where the side and bow transom come together (shown with a disk below) is much closer to the given angle of 127 deg. I can see how that would be confusing but that is the angle you would set your bevel gauge to in order to cut a bevel on the end of the bow transom stiffener. Let me know if that make sense. -Alan
    1 point


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.