shellback Posted February 8, 2007 Report Share Posted February 8, 2007 I have spliced ends in ss wire to form eyes using a die to compress the swages as in a plumber's flaring tool. these flaring tools have a range of hole sizes for different copper pipe dimensions - so bang in your copper swage and screw up the vice voila ze job is done !!!! with luck bill Quote Link to comment Share on other sites More sharing options...
Frank Hagan Posted February 9, 2007 Report Share Posted February 9, 2007 Great tip! That's one of these tools, right? Quote Link to comment Share on other sites More sharing options...
dcannell Posted January 28, 2010 Report Share Posted January 28, 2010 That's actually a flaring tool, used to flare the ends of copper tubing to make a compression joint. There is a tool that looks quite similar, it's called a swaging tool. West Marine carries a couple. http://www.westmarine.com/webapp/wcs/stores/servlet/producte/10001/-1/10001/5657?&cid=chanintel&ci_src=14110944&ci_sku=5657 The difference between the flaring tool and the swaging tool is that the bolts are right next to the item being swaged rather than out at the ends. Much less bend in the steel pieces this way. Dave Cannell Quote Link to comment Share on other sites More sharing options...
PAR Posted January 28, 2010 Report Share Posted January 28, 2010 You do realize that the swage is intended to be compressed to a specific diameter and that over compression will fatigue it. Quote Link to comment Share on other sites More sharing options...
PAR Posted December 8, 2011 Report Share Posted December 8, 2011 Hey Frank, I think she/he's talking to you . . . Quote Link to comment Share on other sites More sharing options...
Frank Hagan Posted December 8, 2011 Report Share Posted December 8, 2011 Hey Frank, I think she/he's talking to you . . . The spammer is gone, and its like he/she was never here! Every now and then, one gets through. Quote Link to comment Share on other sites More sharing options...
PAR Posted December 9, 2011 Report Share Posted December 9, 2011 Come on, it was an ex-wife, you can admit it . . . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.