Jump to content

Deck stringers


bagarre

Recommended Posts

Jeff pointed out that my stringers should go over the masik and not under like I have them. Only the center stringer goes over.

I was going to leave it alone but, after fitting the coaming, I can see that it will change the appearance of the boat a fair amount.

 

As I make the swap, should the stringers terminate at the masik or should they extend a few inches aft? Extending them aft would extend the line in the fabric and may look better.

Thoughts? How have others done this?

 

post-5722-0-61466100-1471527534_thumb.png

Link to comment
Share on other sites


Stretch some T shirt material over it, clamp it and look at it. That is how I do it.

 

A screwed together plywood coaming and sewn in coaming will look different because of the height of the fabric.  Using the t-shirt you can adjust and trim them so they look their best.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.